Homebrew PCBs

I had a sheet of paper jam in the machine, so the toner on it just
wiped off, it was not fused but it was 'stuck' provided I didn't waft
it around in the air.

I fed this sheet through the laminator, it stuck to the copper no
problem, even with the low temp laminator I have.

Going to try that again later, I just thought if I wedge the rollers
of the fuser apart so it applies no pressure or does not touch the
paper at all, I should be able to get a sheet out unfused but fully
printed.

It will need to be handled carefully, but were used to that........


-- 

Lez