Homebrew PCBs

I'm about to get a new laser printer as the last one popped due to power lines falling down here in high winds a few weeks ago and put 450 Volts into mains system.
 
As i will be using this for toner transfer does anybody have a suggestions as to what would be good. I was looking at the HP laser jet 1022 as its 1200 dpi, Don't really want to spend to much as i have a lot of other bits to replace too. 
 
Oh, and i now swear by UPS power supplies with Surge protection, as my PC survived!
 
Gary


----- Original Message ----
From: William Nelson <wnnelson@...>
To: Homebrew_PCBs@yahoogroups.com
Sent: Thursday, February 8, 2007 5:54:17 PM
Subject: Re: [Homebrew_PCBs] Epson Stylus Photo 900 direct inkjet printing

I like the idea of the flat nozzle, I just run the small perhaps .5in round nozzle around until I
push the print button. OK so now a temp sensor that starts the print on reaching the correct temp.
Oh boy something else to make. I don't know if all the "C" models are the same (seems so) but it
doesn't start printing right away each time. Sometimes there is a big delay before print, other
times its immediate. This means I have to keep the heat on and wait.





 
____________________________________________________________________________________
Any questions? Get answers on any topic at www.Answers.yahoo.com.  Try it now.

[Non-text portions of this message have been removed]