Homebrew PCBs

I meant 40 inches per minute....

Mike



--- In Homebrew_PCBs@yahoogroups.com, "Mike Phillips" <mikep_95133@...> wrote:
>
> Hi Mike,
> 
> That 535 laminator has 4 rollers and can go up to 40 feet/min. I have some questions about your process. 
> 
> 1) How long does it take to pass a letter size sheet of paper through lengthwise? My 310 takes 51 seconds.
> 
> 2) How many passes did the board require through the laminator?
> 
> 3) Any mods to the laminator?
> 
> 4) Is the board double sided copper?
> 
> 5) What temp did your laminator show on the LCD at the time of laminating?
> 
> 6) Ever measured the roller temperatures?
> 
> Thanks!
> 
> Mike
> 
> 
> 
> --- In Homebrew_PCBs@yahoogroups.com, michael tenore <wb2lcw@> wrote:
> >
> > 
> > Hi!
> > 
> > I scanned one of my recent boards to the Photo section!
> > This was done with HP Presentation paper and applied to the Board with a GBC H535 Laminator
> > Board is 4.5 x 6.5 inches .062 thick..
> > 
> > http://groups.yahoo.com/group/Homebrew_PCBs/photos/album/1613902738/pic/1067172535/view?picmode=&mode=tn&order=ordinal&start=1&count=20&dir=asc
> > 
> > The board has been etched and drilled but the toner was not stripped off yet..
> > 
> > I will post again when I strip the toner! You can see how nice it came out.
> > 
> > regards
> > 
> > mike..
> >
>