Homebrew PCBs

Ok

I use the slowest speed. a full sheet takes about a minute

I used 10 -11 passes thru the laminator

the laminator is not modified

the board is single sided g-10 .062 thick 4.5x 6.5 inches  .these boards dissipate a lot of heat so more passes with  the
board being re-fed through is necessary to keep the board temp up. I have some .032 boards but I have not put them through  it yet.

My LCD says 328 degrees .I have not measured the temp as I do not have a temp probe.

regards

mike






________________________________
From: Mike Phillips <mikep_95133@...>
To: Homebrew_PCBs@yahoogroups.com
Sent: Tuesday, August 11, 2009 11:50:33 AM
Subject: [Homebrew_PCBs] Re: Picture of board done with HP presentation paper

  
I meant 40 inches per minute....

Mike

--- In Homebrew_PCBs@ yahoogroups. com, "Mike Phillips" <mikep_95133@ ...> wrote:
>
> Hi Mike,
> 
> That 535 laminator has 4 rollers and can go up to 40 feet/min. I have some questions about your process. 
> 
> 1) How long does it take to pass a letter size sheet of paper through lengthwise? My 310 takes 51 seconds.
> 
> 2) How many passes did the board require through the laminator?
> 
> 3) Any mods to the laminator?
> 
> 4) Is the board double sided copper?
> 
> 5) What temp did your laminator show on the LCD at the time of laminating?
> 
> 6) Ever measured the roller temperatures?
> 
> Thanks!
> 
> Mike
> 
> 
> 
> --- In Homebrew_PCBs@ yahoogroups. com, michael tenore <wb2lcw@> wrote:
> >
> > 
> > Hi!
> > 
> > I scanned one of my recent boards to the Photo section!
> > This was done with HP Presentation paper and applied to the Board with a GBC H535 Laminator
> > Board is 4.5 x 6.5 inches .062 thick..
> > 
> > http://groups. yahoo.com/ group/Homebrew_ PCBs/photos/ album/1613902738 /pic/1067172535/ view?picmode= &mode=tn& order=ordinal& start=1&count= 20&dir=asc
> > 
> > The board has been etched and drilled but the toner was not stripped off yet..
> > 
> > I will post again when I strip the toner! You can see how nice it came out.
> > 
> > regards
> > 
> > mike..
> >
>


   


      

[Non-text portions of this message have been removed]