Homebrew PCBs

The thing that's always held me back is the presence of all that existing print on mag/catalog paper. I just think it would ... affect toner adhesion, and smear everywhere. I guess I should try it ..

PG

On 07/04/2010, at 10:24 PM, sailingto wrote:

> > 
> > I still get the best most consistent results using catalogs that come in the mail. I get loads of junkmail printed on that really thin glossy stuff that a lot of magazines are printed on, it practically dissolves in water and floats off, no scrubbing required, even between thin traces. I always found with the photo paper I had to do a lot of scrubbing to clean out small gaps.
> >
> 
> I'd sure like to find some of that magazine paper - the mag paper I've used is a slick glossy type and does a good toner transfer, but is a good bit harder to get off requiring a good bit of rubbing. Perhaps as much if not more than the HP Presentation paper I've used.
> 
> The mag paper I've used is not that thin - it will go thru the printer without taping to a carrier sheet. I'll look for some of the thin stuff that requires a carrier to try that. BTW, you mention "thin" paper, do you use a carrier sheet? 
> 
> I sure though I'd found a great paper in the parchment baking paper - just peeled off - didn't even have to use water. Darn stuff does not do a good toner transfer.
> 
> Ken H>
> 
>