Homebrew PCBs

Sounds like a perfect place for a stepper motor.

Steve Greenfield

--- In Homebrew_PCBs@yahoogroups.com, Richard Spelling <rls@...> wrote:
>
> -----BEGIN PGP SIGNED MESSAGE-----
> Hash: SHA1
> 
> Went to bed tired and annoyed I couldn't easily find a slower gear motor
> for the laminator.
> 
> Dreamed about building a magical speed controller that would let me run
> the existing motor infinitely slow.
> 
> Realized I could use "temporal kinetic and thermal stabilization" since
> it's a worm gear motor.
> 
> I.E., I build a standard PWM controller but set the frequency real
> sloowwwwww.
> 
> Imagine having the speed turned down real low. Along comes a pulse. The
> motor spins up and turns the worm screw a revolution or two, then spins
> down. The board advances a fraction of an inch. An in-determinant amount
> of time later, along comes another pulse.
> 
> Yes, it's "jogging" the board forward and not continuous motion, but
> between jogs it sits between the rollers long enough for the heat to
> transfer through the paper.
> 
> I'm thinking about 10Hz.
> 
> Whatcha think? Just another crazy idear from Richard?
> 
> Now I just need to build the board.
> 
> Wait a second, I need my laminator to build the board to fix the laminator!
> 
> 
> -----BEGIN PGP SIGNATURE-----
> Version: GnuPG v2.0.9 (GNU/Linux)
> Comment: Using GnuPG with Mozilla - http://enigmail.mozdev.org
> 
> iEYEARECAAYFAkvZmXgACgkQ7R3zOzCoP9TDTwCgif7mfECp/31+fYq2RX/lkLca
> rcgAnjxf1FYgfzIrYMy3PBHKB2I1CcW6
> =z+Py
> -----END PGP SIGNATURE-----
>