Yahoo Groups archive

Homebrew PCBs

Index last updated: 2026-04-28 23:05 UTC

Message

Etching Brass

2013-08-23 by RogerRetro

Clark,
I have used the Pulsar toner transfer quite successfully on .005 & .010 brass sheet, and yes, there is some undercutting. It will take a bit of dimensional trial and error if you need high precision.
Regards,
Roger

Attachments

  • No local attachments were found for this message.

Move to quarantaine

This moves the raw source file on disk only. The archive index is not changed automatically, so you still need to run a manual refresh afterward.