Homebrew PCBs

That's the one I bought 26711.
Small but takes my Expo mini drill.
With the three shafts run out is minimal, fine for my needs.

John  




From: arvidj@... 
Sent: Saturday, September 28, 2013 2:38 PM
To: Homebrew_PCBs@yahoogroups.com 
Subject: [Homebrew_PCBs] RE: Expo Drill Stand 14211


  

As a follow up to this thread ...




I ordered the Jameco Drill Stand Works with Mini Drill (Part 26702) ...




http://www.jameco.com/webapp/wcs/stores/servlet/ProductDisplay?langId=-1&storeId=10001&catalogId=10001&productId=26711




Note that I did not order the Miniature Drill 12000 RPM associated with it ... 





http://www.jameco.com/webapp/wcs/stores/servlet/ProductDisplay?langId=-1&storeId=10001&productId=26702&catalogId=10001&CID=MERCH




because I have a Dremel 4000 and was hoping to use that.





Regretfully the stand is not capable of supporting the Dremel 4000 securely. The Dremel 4000 is just too big and heavy.




I am not sure if I will bother to get the "correct" motor. While I will admit that for $28 plus shipping the stand is reasonably solid I feel the term "will not be solid enough even with the smaller motor" applies.




---In homebrew_pcbs@yahoogroups.com, <v321uk@...> wrote:


Here are some comments I found on the PZ541 

http://www.electro-tech-online.com/general-electronics-chat/122682-time-new-drill-stand.html






From: arvidj@... 
Sent: Thursday, September 05, 2013 4:50 PM
To: Homebrew_PCBs@yahoogroups.com 
Subject: [Homebrew_PCBs] RE: Expo Drill Stand 14211


  

It appears to be the same as a "PZ541 Vertical Drill Stand".




I do not have either one. Just wanted to pass along an additional set of 'tokens' to Google for information.




--- In homebrew_pcbs@yahoogroups.com, <v321uk@...> wrote:


Does anyone here have experience in using an Expo 14211 mini drill stand?

Intended use occasional PCB making.

Is there much 'run out' ?

Would you recommend it ? 
I tried searching the group but cant see a text search only a message number search. 
Thanks, John G3UGY