Yahoo Groups archive

Homebrew PCBs

Index last updated: 2026-04-28 23:05 UTC

Message

Re: [Homebrew_PCBs] DIY Drill press for Dremel type tool

2015-08-18 by bobledoux@...

As a hobby builder I drill FR-4 with steel bits. They dull more quickly, but they are cheaper and will not shatter when used in sloppy tolerance hobby tools. Carbide bits require collet chucks in very precise spindle bearings.

I use 1/32, (.032) diameter bits for most through hole construction. These cost about 50 cents each when purchased in 12 or 24 packs from buydrillbits.com. ( I have no financial interest in that company.) The 3/64 bits are used for larger component leads.

Numbered bits are more expensive

Attachments

  • No local attachments were found for this message.

Move to quarantaine

This moves the raw source file on disk only. The archive index is not changed automatically, so you still need to run a manual refresh afterward.