Apple Logic Pro /LogicExpress Discussion group photo

Yahoo Groups archive

Apple Logic Pro /LogicExpress Discussion

Index last updated: 2026-04-28 23:06 UTC

Thread

using a controller to a rythmic modulation step sequencer

using a controller to a rythmic modulation step sequencer

2005-08-02 by musicfromdenmark

Turning Peavy PC 1600 (or other controller) faders into a 16 step 
rhytmic modulation-wheel generator ?

I would like to use my PC 1600 faders to control 16 modulation-wheel 
steps (or other CC), to get a 16 step rhytmic filter sequence, I can 
route to any synth, (midi or internal). 
Each fader should control the modulation-wheel level (or other CC) in a 
16th note step sequence, but only sending out CC data.

Any ideas ?

Futhermore it would be nice to use the on-of buttons to mute the steps, 
in order to make other than straight 16 steps rythmic sequences.

I would be thankfull for any feedback ;-)

Re: [Logic_Cafe] using a controller to a rythmic modulation step sequencer

2005-08-02 by Neil Goldstein

----- Original Message -----
Sent: Tuesday, August 02, 2005 7:25 AM
Subject: [Logic_Cafe] using a controller to a rythmic modulation step sequencer

Turning Peavy PC 1600 (or other controller) faders into a 16 step
rhytmic modulation-wheel generator ?

I would like to use my PC 1600 faders to control 16 modulation-wheel
steps (or other CC), to get a 16 step rhytmic filter sequence, I can
route to any synth, (midi or internal).
Each fader should control the modulation-wheel level (or other CC) in a
16th note step sequence, but only sending out CC data.

Any ideas ?

Futhermore it would be nice to use the on-of buttons to mute the steps,
in order to make other than straight 16 steps rythmic sequences.

I would be thankfull for any feedback ;-)



No virus found in this incoming message.
Checked by AVG Anti-Virus.
Version: 7.0.338 / Virus Database: 267.9.8/61 - Release Date: 8/1/2005

Move to quarantaine

This moves the raw source file on disk only. The archive index is not changed automatically, so you still need to run a manual refresh afterward.