QTR-Quadtone RIP

In Spyder3Print you pull down <Tools> and choose <Calibrate>. Then pull
<Tools> down again and select <Measure>. In the Measure tool click on
<Export to...> and choose a file name and location. Once done you have to
specify either Lab or Density, and then take your measurements.

Terry.

On 12-01-18 5:12 PM, "Keith" <kjrslr@...> wrote:

> Thank you both, Mike & Terry!
> I did make the calibration print with the slider indicating 100, so it sound
> that at this point I'm good to go. For now. Until my next question. If it is a
> typo, it's gone unquestioned for almost 7 years.
> My next question concerns reading the cal print. The last time I went through
> this(I did this ONCE-well over a year ago) I used my DataColor
> spectrcolorimeter, but can't remember the steps I took. Since all the
> documentation involves the Eye-One, is there anyone that uses the DataColor
> spectro. I know it can be done, I just don't remember how.
> Thanks! 
> 
> --- In QuadtoneRIP@yahoogroups.com, Terry Ritz <t.ritz@...> wrote:
>> 
>> That must be a typo. You want the calibration slider set to 100 to determine
>> how the paper responds to a full ink load. Measuring the step wedge that's
>> printed will then help you determine where to set the ink limit for the
>> paper. You will set the calibration slider to the ink limit value when you
>> make your second calibration print.
>> 
>> Terry. 
>> 
>> On 2012-01-17, at 8:36 PM, "Keith" <kjrslr@...> wrote:
>> 
>>> "To print the first Ink Separation Test Page, place a piece of the paper for
>>> which the Curve will be designed in the printer, make sure the calibration
>>> slider is ALL THE WAY TO THE LEFT(100), click the Print button and you're
>>> off."
>>> 
>>> However in the ink calibration box(in the calibration mode) the slider is
>>> all the way to THE RIGHT and the box indicates 100.
>>> So which why should the slider be placed? All the way to the left,
>>> indicating 1, or all the way to the right, indicating 100.
>>> 
>>> So which is it?