QTR-Quadtone RIP

Thanks Mike

I've found the alignment utility and have reset the alignment.  I can't see any micro banding now.  However the longitudinal "streaking" is still visible.  This appears t only affect about 3" in from the left side in areas of uniform dark tone.  Still non plussed, as it is noticeable in landscape and portrait mode.  i.e. parallel to the left edge in terms of paper transit and also parallel to the bottom edge????

Ross

--- In QuadtoneRIP@yahoogroups.com, Mike Finley <mike.finley@...> wrote:
>
> On the R2400 the nozzle check shows a pattern of short thin lines, and 
> misalignment shows by one of the lines being out of position. I think 
> some of the Epson printers have different nozzle check patterns that use 
> small blocks rather than lines, than could mask this problem. Problems 
> at the start and end of the page can also be a symptom of this (at least 
> on the R2400), but can also have other causes. (I no longer use the 
> 2400, so this is from memory.)
> (on Windows the QTR print process uses a much less complex printing 
> pattern than the Windows print driver, so printing with QTR could show 
> problems  while the Windows printer driver didn't)
> 
> On 27/02/2013 00:08, rossfmj wrote:
> >
> > Mike
> >

> -- 
> mike finley photography
> http://www.mikefinley.co.uk
> http://words.mikefinley.co.uk
> http://www.roguegenegallery.com/Mike_Finley-gallery.html
> 
> 
> 
> [Non-text portions of this message have been removed]
>