Hi Roy,
Is there a risk that this will affect the perception of the set height by the printer?
:)
Cheers
JF.
2013/9/18 Roy Harrington <roy@...>
61cm is too large I.e. > 24in. Use 60.9 cm.
Roy
On Wednesday, September 18, 2013, J.F. Felinik wrote:
Hi,I'm setting up a paper size for my Epson 7600 in QTR Print Tool, width 61cm (full roll width as I am using the 24" roll), and then I set the height to 35cm. For some reason the paper is in the end after cut from the printer, only 34cm high! I have had this several times now and first I thought it was my bad, second that the paper feed in the printer did something wrong, but now I am sure something is not quite right here.It becomes quite a problem as I'm printing using Piezography for glossy prints, so I need to feed the cut sheet back to the printer for GO overcoating, and with 1cm missing, the margin the printer need for holding the sheet at the end of the sheet, is now gone...Any ideas?CheersJF.
--
Roy Harrington
roy@...
www.harrington.com