QTR-Quadtone RIP

Dear Mr. Boutwell,
Not sure if you meant your answer to me. But, I don’t use any specialty inks. I use the Epson K3 inkset.
Also, I have no clue what you mean by a bad quad profile. I wish I could get this thing better understood, it is costing me a lot in ink and paper……
Any guidance will be greatly appreciated.
Regards,


Moises Faidengold


This transmission is intended to be delivered only to the named addressee(s) and may contain information that is confidential, proprietary, and privileged.  If this information is received by anyone other than the named addressee(s), the recipient should immediately notify the sender by E-MAIL . In no event shall this material be read, used, copied, reproduced, stored,  shared or retained by anyone other than the named addressee(s), except with the express consent of the sender or the named addressee(s).
Esta transmisión tiene como objetivo su llegada única y exclusivamente al destinatario identificado arriba y puede contener información confidencial, de uso privado y confidencial. Si esta información es recibida por otra persona distinta a quien esta identificado como destinatario, el receptor desde informar inmediatamente al remitente por correo electrónico. En ningún caso este material puede ser leído, copiado,reproducido, archivado, compartido o retenido por cualquier otro que no sea el destinatario.


> On Nov 28, 2014, at 12:57 PM, richard@... [QuadtoneRIP] <QuadtoneRIP@yahoogroups.com> wrote:
>
> In almost all cases, this is due to a bad .quad profile that was made with incorrectly set gray values or the overall gray curve is wonky. Based on just the measurement data, it looks like the Gray_val= settings are wrong, but that is without knowing what inks or printer you are using. (it looks like it would be the K3 inks since there are three spots where the curve has flat spots). Is this a profile you made one that was provided someplace else?
>
>
> Richard Boutwell
>
>