QTR-Quadtone RIP

Sigh...
Beat head against desk...

Yup, there it is!  I thought I'd done that, but somehow managed to
screw it up.  

Many thanks for your patience and help for this newbie.

Dave K

--- In QuadtoneRIP@yahoogroups.com, "Tom Husband" <thusband@s...> wrote:
>
> Dave,
> 
> When you open QTR you should: 
> Click on Curve Creation and open the Curve Creator.
> Then File->Open to find the 1160 curves.
> Save the opened curve as something else.
> Create the new curve and hit the Create Curve button.
> Then I always save it again but I'm not sure that's necessary.
> 
> It should be there now.
> 
> Tom
> 
>   ----- Original Message ----- 
>   From: davidkeasey 
>   To: QuadtoneRIP@yahoogroups.com 
>   Sent: Saturday, December 03, 2005 5:54 AM
>   Subject: [QuadtoneRIP] Trouble creating curves...
> 
> 
>   I have been trying to build a set of curves for my Epson 1160, using
>   the UT2 inks.  When I load the QUAD1160-UT Printer Model, I can then
>   find four sets of curves for the 1160, two for UT and two for the
VM inks.
> 
>   However, when I try to create a curve, I cannot find these curves to
>   use as a starting point. 
> 
>   Furthermore, when I try to build a curve from scratch, I can save the
>   curve just fine, but then QTRGUI doesn't find the recently-built
>   curve. I can't use it for a test print or go beyond the initial
>   curve-building step.
> 
>   Am I doing something dumb here?  
> 
>   Thanks for any help with this.
> 
>   Dave Keasey
>