QTR-Quadtone RIP

Tom,
 
 
Thanks so much...I had looked previously but didnt see it......I will check
it out.
 
Paul

-----Original Message-----
From: QuadtoneRIP@yahoogroups.com [mailto:QuadtoneRIP@yahoogroups.com] On
Behalf Of Tom Moore
Sent: Tuesday, August 19, 2008 2:56 PM
To: QuadtoneRIP@yahoogroups.com
Subject: RE: [QuadtoneRIP] MIS UT3D Ink in Epson 2200



Paul

There's a UT3D curve for the 2200 in the files section of the QuadtoneRIP
yahoo group pages here:

http://tinyurl. <http://tinyurl.com/6ectfa> com/6ectfa

It uses the UT7 printing model.

Tom Moore

> -----Original Message-----
> From: QuadtoneRIP@ <mailto:QuadtoneRIP%40yahoogroups.com> yahoogroups.com
[mailto:QuadtoneRIP@ <mailto:QuadtoneRIP%40yahoogroups.com> yahoogroups.com]
On
> Behalf Of Paul Grant
> Sent: Tuesday, August 19, 2008 5:35 PM

...

> I have just installed a set of MIS UT3D inks into my Epson
> 2200. I am looking for what curves to use for QUAD2200. Is the UT7 a
> good place to start or are there curves somewhere that I can use to get
> started.
> 
> Regard's
> 
> Paul



 



[Non-text portions of this message have been removed]