QTR-Quadtone RIP

Paul,

The UT3D that I am using were commercially filled cartidges.   I am very
dispointed.   A lot of money down the drain.

Wish I would have know that information up front.

Paul


On 8/25/08 1:11 PM, "Paul Roark" <paul.roark@...> wrote:

>  
>  
> 
>> >... all I get is random nozzle checks. Its purely random.
>> > I run the head clean then print and its totally random.
> 
> It sounds like air.  If the carts were not loaded with a good vacuum, they
> could need priming.  I use a modified MIS bottom fill adapter (see
> http://www.paulroark.com/BW-Info/Modified-Bottom-Fill-Adapter.pdf -- used
> with a syringe) to pull the air out of the outlet when something like this
> happens.  For this, I hold my finger over the air inlet (I assume that tab
> has been removed) and have the plug into the reservoir removed.  This should
> not be needed with a commercially filled cart, but it does occasionally.
> 
> Paul
> www.PaulRoark.com
> 
>  
>          




[Non-text portions of this message have been removed]