QTR-Quadtone RIP

Phil,

That is a good suggestion, and I have seen that problem in the past, but that wasn't the source this time.  I think I had a little too much bumpiness in the density readings, so even though it was constantly increasing, the algorithym for the linearize program was seeing a flat spot that caused it to reject.

This is effectively what happens when the ink limit is set too high as well, but the levelling happens at the end of the curve.


Thanks,


---Michael



--- In QuadtoneRIP@yahoogroups.com, "grimmieoldfart" <grimmieoldfart@...> wrote:
>
> Try decreasing the ink limit one or two steps. I seem to be spending alot of time trying to linerize & profile BFK Rives and I often get teh same error message using the 21 Step grayscale and Black Only ink. Not much room for error. Last night for example, I was using an ink limit of 40 for Cyan only and it wouldnt linerize until I dropped it to 30. 
> 
> Phil
> 
> --- In QuadtoneRIP@yahoogroups.com, "mjmptpd" <michael@> wrote:
> >
> > 
> > OK, I answered the second question last night.  It just took a while to find where it was placing the QUAD files...
> > 
> > Still no information on the linearize problem...
> > 
> > 
> > ---Michael
> >
>