Bullseye Targets
2011-10-01 by vollaro.giuseppe
Hi, I am starting experimenting with Ebony-6 MIS ink. I have done the ink separation and I have printed the 21 Steps test strip; the result was very good! Then, I printed the bullseye target and I notice that the transition was almost good but there are two zones where the grey does not follows the gradient and it has a two darkest zones. I have done the linearization but the situation has become worst! maybe is a problem of dot gain or something else? I am using a Mac with Leopard and a R265 which is the european version of the r260. Thanks, Giuseppe