--- In SergeModular@yahoogroups.com, kimgh@... wrote:
Does anyone have a XFAD that could attempt the same with? (feed it two audio signals and
a steep CV to see if it will do a hard jump-cut without audible "fading" between the
signals)
Thomas
>Thanks for the second opinion!
> I also tried it last night and found that
> the switching is audible - albeit subtly so.
> I tried recording and looking at the result
> in a waveform editor. It seemed there was a
> minimum crossfade time of up to 30-40 ms.
> However from looking at the waveform it seems the major
> part of the crossfade is over after about 5-10 ms.
>
> actually i like that my acpr has this "slew"
> Its nice and musical instead of the clicks and distortion
> that i think a near-instant crossfade would impart to
> the sound.
Does anyone have a XFAD that could attempt the same with? (feed it two audio signals and
a steep CV to see if it will do a hard jump-cut without audible "fading" between the
signals)
Thomas
>
> apples and oranges, as always.
>
> Kim
>
>
> Citat paradigmshiftbeats <paradigmshiftbeats@...>:
>
> > --- In SergeModular@yahoogroups.com, "paradigmshiftbeats"
> > <paradigmshiftbeats@> wrote:
> > >
> > > I know I've done "hard switching" between two ACPR inputs using
> > > the Sequencer in the past. I'll try again tonight using a DSG if
> > > I can find the time and report back.
> >
> > I checked this tonight and can confirm that the hard switching is
> > achievable possible using the gate output of a cycled DSG/DTG. No
> > audible slewing, and in fact this switching works effectively even
> > when being driven by audio rate modulation from the DSG, producing
> > nice Fm/sideband effects!
> >
> > Chris
> >
> >
>