SergeModular

hello Harry,

ok, thanks!

so, from your info, the molex connector on the back of
the m-boats should be a Male, right?
( i assume that because the male end of PBX goes to
the female connectors of the PSD, and so, the female
end of the PBX goes to the male connector on the back
of the m-boat...? also, what about the watts of the
step-down transformer i asked you about?

many thanks for all the info!
best regards, :-)
Bakis.


--- Harold Tique <sts7@...> wrote:

>
> Good Morning Bakis,
>
> One M-boat has a power requirement that is
> equivalelent to a
> STS/Serge panel (Shop series or Custom).
>
> What you have, Bakis, is a [PS12] as denoted by the
> four 5-pin "XLR"
> connectors. --(The [PS6] has two)
>
> Your [PS12] implied by the designator, up to 12
> panels. So you will
> have plenty of room to grow your STS/Serge.
>
> Please note that AC line Voltages in Europe/U.K. (&
> the lower half
> of Japan) all have 50 Hz as the standard. This
> derates power supplies
> Dc outputs by approx 15%.
>
> What you need to connect your "M-boat to the [PSD],
> running off the
> [PS12], is a [PBX] "Power Braid Extender" cable (18"
> long) OR a
> [PBXL] "Power Braid Extender Long" same except (24"
> in length).
>
> Both length extenders are Male MOLEX on one and
> Female MOLEX (4-pin)
> on the other end.
>
> These are hand braided and $ 20 / $ 25 each,
> respectively.
>
> No [PS2a] is required given your configuration.
>
> Best,
>
> Harry Tique
>
>
> STS
>
>

____________________________________________________________________________________
Be a better friend, newshound, and
know-it-all with Yahoo! Mobile. Try it now. http://mobile.yahoo.com/;_ylt=Ahu06i62sR8HDtDypao8Wcj9tAcJ