SergeModular

It works! Thanks, again, everybody...
Matt

On 3/15/08, matthew carpenter <matfhew.carpenfer@...> wrote:

Ah, I'll have to try that!

What I'd been doing before this was using the NCOM after the PDIV rather than the PDIV after the NCOM.

Thanks,
Matt

On 3/15/08, Kim Hansen <kimgh@...> wrote:

The way i make a 16 step out of my SEQ is
to feed the gate from a DTG both to the SEQ clock input and into the
+in input of my NCOM
the NCOM is set to divide by 2
Then i patch output of NCOM into my PDIV and use the 1/8 output to
switch the ACPR

Kim

On Mar 14, 2008, at 1:44 PM, matthew carpenter wrote:

> Thanks! It's funny... I tried that... and that's exactly how you do it
> with the SQP for making an 8 step sequence out of two rows of 4. (I
> use an ACPR rather than an XFAD). In that case, you actually need to
> use the / 8 output not the / 4.
>
> If I use 1/8 the freq. of the main clock for the 8x2 Sequencer, it
> jumps to row B after only 4 steps. I either need another PDIV (to
> divide by 2, again) or some other way of effectively dividing the
> clock. I have tried my NCOM, DTGs, and VC Clock but it doesn't seem to
> work quite as perfectly as the PDIV.
>
> I hadn't thought about using a S&H but I was playing with my, NCOM,
> Dual Schmitt Triggers and BLOG and, while not achieving the results I
> was aiming for, I came across numerous other cool tricks!
>
> Matt

>
> On 3/14/08, kkonkkrete <kkonkkrete@...> wrote:
>> OK, this is a bit of a guess as I don't actually own one, but here is
>> a workaround I think should work:
>>
>> - route A and B outs to the two ins of a VC X-fader
>> - apply a square wave at 1/8 the freq of the main clock to the VC In
>> of the X-fader.
>> - The out of the X-fader will alternate between 1 cycle of A and 1
>> cycle of B.
>>
>> Now the question is how to get a square wave at 1/8 clock speed.
>> Seems
>> you should be able to do this with a PDIV and an S&H unit.
>>
>> Pure speculation until I get my system, of course ...
>>
>> Kinkrot
>>

>> --- In SergeModular@yahoogroups.com, "matthew carpenter"

>>
>> <matfhew.carpenfer@...> wrote:
>> >
>> > Hi,
>> >
>> > I know how to make an 8 step sequence with the 4 Stage Sequencer
>> Programmer
>> > [SQP] using an Active Processor [ACPR] and the Pulse Divider [PDIV]
>> but I'd
>> > like to know if anyone's discovered a way of chaining the two rows
>> of the
>> > 8x2 Sequencer [SEQ] to make a single 16-step sequence.
>> >
>> > Since the [SEQ] doesn't have GATE OUTPUTs, I'm trying various
>> patches
>> > incorporating the Schmitt Triggers [STR] but it's not quite
>> happening.
>> >
>> > Thanks!
>> > Matt
>> >
>>
>>
>>
>
>
>