SynthModules

Larry,

Yes, the users of the partials (for the Stooge panels) are supplying their 
own pushbuttons and jacks.

I am supplying the nice black 4-40 screw and nut to mount the LED board to 
the panel (the LEDs act as stand-offs).  The hole for *that* screw is the 
same diameter as the T1 LED holes which is 3.2mm (0.1260").

For those interested (and if they want to use the same pushbutton)... the 
pushbuttons I am using on the completed PSIM-1 frac-rack panels are machined 
to 4.5mm (0.1772") diameter and I'm using three (3) ITT Cannon (C&K) 
Pushbutton Switch MOM-(N/O) SPST (Mouser Part# 611-8631-252).  Here is a 
link to the datasheet for the switch:
http://www.ittcannon.com/media/pdf/catalogs/Leaf/SW_push_8600.pdf

It's a very small pushbutton switch.  Anyway, any MOM-(N/O) SPST switch will 
work fine.

I hope this helps...

- Brice
http://www.SynthModules.com

----- Original Message ----- 
From: "Larry Hendry" <hendrysr@yahoo.com>
To: <SynthModules@yahoogroups.com>
Sent: Tuesday, October 26, 2004 10:05 PM
Subject: [SynthModules] Brice... Help !!


>
> Hey, this may be of general interest, so I made it public.
>
> I am drilling a PSIM-1 panel for a customer.  I have one question.  I
> cannot figure this out on my own since I don't have my PSIM-1 just
> yet.
>
> Are the pushbuttons panel mount so that they are also supplied with
> the PSIM-1 even for those building on large format panels?  If so,
> what size is the hole?  If not, I assume the user is supplying his
> own pushbuttons and that will determine the size.
>
> Thanks
> Larry
>
>
>
>
> __________________________________
> Do you Yahoo!?
> Take Yahoo! Mail with you! Get it on your mobile phone.
> http://mobile.yahoo.com/maildemo
>
>
>
> Be sure to check out the primary Web site at:
> http://www.SynthModules.com
>
> Yahoo! Groups Links
>
>
>
>
>
>
>