Analogue-sequencer

> the BOM states that all resistors should be 0.6W, but those seem to be
> impossible to find over here. is that a typo? should it be 
> .5? i've even
> searched for "2/3 resistor" and have found nothing helpful...

It's not critical - even 0.25w should be fine. The important thing is to
get them to fit 0.3" hole spacing.

> in the instructions on the webpage, it seems that you have the two pot
> boards and the led and switch boards going into the same 
> IDC16 header on
> the main board... the secret being a connector in the middle 
> of the cable.
> could you give us the details of this connector and how to hook it up?

Eh, no - the two pot boards connect to the POTS connector on the main
board, and the three LED & switch boards connect to the LED/SW connector
on the main board.
The Pot bus cable is shown here:
http://www.colinfraser.com/p3/images/pot-board-wiring.jpg

And LED/Switch bus shown here:
http://www.colinfraser.com/p3/images/sw-LCD-wiring.jpg

Both shown on this page:
http://www.colinfraser.com/p3/p3-build-final.htm

There are other photos where the routing of the cables is less obvious.
I'll need to write some instructions for assembling the cables - I have
to measure the spacing of the connectors up each time I put a set
together myself, so it would make sense to write them down.

Cheers,
Colin f