Analogue-sequencer

On Sat, 29 May 2004 09:45:58 -0700, Gene Schwartz
<implode7@comcast.net> wrote:

>Well, this is a pretty basic question I guess, but I've only had a few hours
>on my new P3, and I'm trying to figure out from the manual how to do
>something that should be pretty straightforward - how to change the
>controller number on a particular step of a pattern. Changing the value sent
>out is easy - but I want to change the controller number.

You mean you want to send (for example) CC1 on step 1, CC2 on step 2,
CC10 on step 5 and so on? No can do - although obviously you can send
4 controllers A-D and each can be the controller you want and active
on each step.
I reckon that's far from basic, personally dude.... 8-)

>I'm in edit mode. The upper blue button is selecting 'aux'. I press the func
>key plus the step 14 key (for the relevant step in the pattern), and I see
>the aux function assign menu which says cc # 0.  But I haven't been able to
>figure out how to change it, or how to change to the aux events menu. The
>Data knob doesn't seem to do anything, and the page key doesn't seem to
>bring up the aux events list.

Function plus the bottom mode button (mine's red), then use Page to
toggle between Controllers and Aux events and the data entry to scroll
through the controllers/auxes available. If you do Function plus the
button (not a step button - that just peeks the value) repeatedly it
tabs between the four controllers. 
Hey Colin, does that button have a name? Other than "the red one" that
is <g>?

>So, I figure that I'm confused on a very basic point, but I've already spent
>more than an hour trying to figure this out, and would appreciate someone
>leading me out of my puzzlement.

Hope that helps - if not, fire away! If it's any comfort, once you've
gone past a certain learning barrier, it all just kinda clicks in. At
least, it did with me. But I understand....

Paul
---
Paul Nagle / Soft Room Music
Email: paul@softroom.co.uk www.softroom.co.uk
                           www.BogusFocus.com