Analogue-sequencer

> i tested the fts function, but probably i didn't get that:
> is it possible to set the note range for each pattern like min. c1 to
> maximum c4 (between all notes possible) or something?

Not with FTS no - it just forces notes into the defined scale in the
original octave.
I'm planning to add some events to limit and compress note ranges.

> is it possible to
> force a pattern to the same notes, same velocitys and same gates as
> first note on the pattern?

You mean just to initialise the pattern to the same notes ?
If you 'clear' a pattern, all notes and velocities are set to the values on
the step 1 knobs.
Or you can use the Sculpt function to 'draw' the values using the data knob.

> i tried to set the cc# number
> for the upper knob row but i'm not able do it, its evertime cc# 0, any
> idea?

When you have selected 'aux' for the upper knob mode, the step key mode
switch cycles through the 4 auxes. FUNC+step key mode brings up the assign
menu for the current aux. Then you use the data knob to select the
controller number.

> (colin, the p3 manual is fine but sometimes its hard to get the right
> function as a foreigner....;-)

I'll try writing it in UPPER CASE THEN ;-)

Cheers,
Colin f



________________________________________________
Message sent using UebiMiau 2.7.2