Analogue-sequencer

The checksum thing is a check on the o/s in the firmware.

Thats assuming that the "flash" option works though.  Mine takes a long time to respond (yes, theres probably somthing not quite right with it, but it works... eventually) so try pressing flash, and then waiting 5 mins or so and see what happens.



If it works, then you could grab a o/s revision form the files section, and dump that to the p3 via sysex. (midi-ox on a pc will do it for free...)

Incidentaly, i had to mess with the time pause between frames (?) on the sysex dump too, in order to get things right.

Worth a go maybee, unless someoen who knows better says somthing else?

Julian

  ----- Original Message ----- 
  From: Robert Holmström 
  To: analogue-sequencer@yahoogroups.com 
  Sent: Thursday, September 23, 2004 7:29 PM
  Subject: RE: [analogue-sequencer] Can't start my P3


  Hmmmm... just noticed that I get text... just had to turn the trim pot...

  What I get is the "check fail 63ED" message and the boot and flash options, 
  but I can't get out of there. Do you think it can be the ribbon contact for 
  the keypad? Should it answer to F1 or F3?  Is there any way I can check the 
  ribbon contacts?

  Thanks

  Robert


  >Hello,
  >
  >I just finished my P3 and I can't get it to boot. First time I
  >powered it up it did a small flash show and ended up with all lights
  >on the step row on. Then I remembered I had read somewhere that a
  >conbination of keys had to be held down the first time I power it up.
  >I checked the manual and tried to hold down F1 and step 7 but nothing
  >happened (the same sequence was played again and stopped at all
  >lights on). I tried again and now something happened... the lightshow
  >didn't start and just two leds were lit, the "tie" and "x".
  >
  >I haven't seen any text in the display yet.
  >
  >ANybody who can help me?
  >
  >THanks
  >
  >Robert
  >

  _________________________________________________________________
  Hitta rätt på nätet med MSN Sök http://search.msn.se/


        Yahoo! Groups Sponsor 
              ADVERTISEMENT
             
       
       


------------------------------------------------------------------------------
  Yahoo! Groups Links

    a.. To visit your group on the web, go to:
    http://groups.yahoo.com/group/analogue-sequencer/
      
    b.. To unsubscribe from this group, send an email to:
    analogue-sequencer-unsubscribe@yahoogroups.com
      
    c.. Your use of Yahoo! Groups is subject to the Yahoo! Terms of Service. 




[Non-text portions of this message have been removed]