Analogue-sequencer

--- In analogue-sequencer@yahoogroups.com, "Colin f" 
<colin@c...> wrote:

> When you have selected a part chain, part 1 should start red 
with part 2
> flashing amber.
> Then when part 2 plays, it'll be red and part 1 will be flashing 
amber.
> And so it will loop...

Well, what is happening to me is that Part 1 is red and Part 2 is 
amber, but once it goes through the cycle once, it stops cycling 
and just stays on one Part. I have to manually reset the chain.

Is there a user config that needs to be set to enable a latch on 
the loop?

I'm totally rearranging my studio at the moment so it will take me 
a day or so before I have everything set back up and can give all 
a try again.

-Jim
 www.touchxtone.com