Analogue-sequencer

In the most recent P3 release firmware, if you use FUNC + RUN instead of
just RUN, P3 will send a CONTINUE MIDI message rather than a START.
It does not actually continue from where it last stopped - it resets to the
start as usual, but the sending of a CONTINUE should prevent 
software sequencers from re-starting at the beginning when you want to
restart from the beginning of a specific bar.
So you may get away with using P3 as master.

This is an undocumented feature because I may decide to remove it, unless it
turns out to be useful...

Best regards,
Colin Fraser
Sequentix Music Systems Ltd
http://www.sequentix.com