Analogue-sequencer

> separate   midi outs   A   B    C   D   like   the akai mpc 
> 60/3000 would   
> be So   nice.   after all there   is   4   midi outs   on the 
>   p3   hint hint.

It would need some extra hardware on the mainboard for that. The CPU only
has a single serial interface.
It's possible at some time I might work out a way to add the extra
circuitry, but not a top priority at the moment.

> Is there a function that   enables   you   to   trim   all 16 
>   knobs   with  
>  just one   pot   all at once?

The Sculpt function allows you to write in values with the DATA knob as the
sequence plays.
You hold the 'note' or 'upper' softkey while tweaking the knob, but if you
just leave it still, the same value will quickly go into all steps.
 
> also,   when   touching   a knob    for   note selection . .  
>  it always 
> seems   to jump to a different note
> just   by slightly   touching it ..

One solution for that would be a pass-through knob mode, or relative mode.
I haven't been pestered enough to do either of those yet (ducks).

> last   but not least ..    the    led    level Meters. 
> are they arbitrary?   ive not   yet figured   out   exactly   
> What they 
> monitor.   track 1 & 2's    midi   velocity?   and   they   
> stop working   if   the 
> velocity   is   lower than   say   50???     they 've   
> seemed   to be    a 
> bit   intermitent. .    or   maybe   i am?

In VU mode, on group shows odd track velocities, the other shows even.
All velocities get added together, and as the result passes different
thresholds, more LEDs light.
Pressing STEP MODE will toggle through some other LED modes, one showing
Gbar beat position, the other showing the countdown to Gbar reset in binary
(easier to follow than it might sound...)

> the P3   always leaves me   with my jaw   dropped in awe.
> thanks   colin!

No problem ;-)

Best regards,
Colin Fraser
Sequentix Music Systems Ltd
http://www.sequentix.com