Analogue-sequencer

Hi Paul,

Back from your hols then?

> 
> How did it all go?
> Any problems with the holes? I think I remembered to send Steve 
all the
> changes needed.

Steve implemented all the changes he received, but I found that I 
still needed to hack 5mm of of the bottom of the keypad board 
because it was fouling the upper pot board.

Also the some of the step switches and keypad switches would jam 
so I had to get the file out and enlarge some of the holes. I reckon 
the switch holes should be enlarged by 1mm to allow for a bit of 
'slop'.

Mounting of the boards is made easier by enlarging the pcb 
mounting holes so that the boards can be wiggled a bit on the 
pillars.

So, all in all, it was not as straightforward as I'd hoped, but with a bit 
of fiddling, end results are pretty good.

I did pass this info on to Steve, but it might be worth getting in touch 
with him to confirm that he has all your mods.

Nice layout though Paul, so thanks for that. I know Colin has 
reservations about not having the function switches directly 
underneath the display, but I don't find that a problem.

All the best

Andy
--
Andy Wilson
http://www.techman.synth.net
mailto:andy@techman.synth.net