Analogue-sequencer

Hi Paul,

>  just reading my e-mail from Spain :-)

:->)
> 
> > Steve implemented all the changes he received, but I found that I
> > still needed to hack 5mm of of the bottom of the keypad board
> > because it was fouling the upper pot board.
> 
> blast, I forgot about that..
> I mounted the pot board upside down and soldered wires on to 
reverse the 0v
> and 5v end.

Ah, so that's how you did it. I just got the hacksaw out, but it meant I 
had to cut through the bottom two keypad mounting holes though. 
Not too much of a problem, as the keypad is wedged so tight against 
the pot board, that I could fit a couple of 3mm nuts on long screws to 
keep everything in place. (A photo would be handy here to explain 
that last paragraph!)
> 
> > Also the some of the step switches and keypad switches would 
jam
> > so I had to get the file out and enlarge some of the holes. I 
reckon
> > the switch holes should be enlarged by 1mm to allow for a bit of
> > 'slop'.
> 
> Hmm, I thought this could be the case, the holes were already 
1mm wider
> trhan before.. I guess they need to be 11.5mm, Drop Steve an e-
mail and let
> him know.

Have done.

Have fun on the beach.

Andy
---

Andy Wilson
http://www.techman.synth.net
andy@techman.synth.net