Analogue-sequencer

Colin,

> Can't remember off the top of my head - either check out the .fpd  file
> on my webpage, or I'll check myself when I get home.

yeah I just remebered that :-)
Got it thanks.

> The spacing may be slightly different for tact switches, but the
> centres will be the same.

Its the centers Im after...

> Also, the mounting points at the mid-point of the switch/LED board
> will be rationalised, since I'm no longer using 2 separate boards -  my
> home PCB etching equipment has a 8" size limit.

Ahh, ok, so in the middle of step 8 and 9...

> The horizontal spacing of the switches and pots is 19.05 mm, or 0.75".
> The gap between the pot boards and the switch board can be varied to
> taste. Putting these boards as close as they can go is not very
> ergonomic. I think I've got them about 20mm apart vertically.

Ive just taken the strip from your rack, and used that.
Replaced the rectangle whole with 16 round ones (for tact switchs)

I've also replaced the square 9 switchs with 9 round ones (tact again,
though the centers for these is a complete guess... (anyidea?)

once done, I'll put the fpd file on my webpage somewhere so anyone who is
thinking of using those cases can use the same layout if they want.

Paul