Analogue-sequencer

Hi Julian, 

> I have one of the pre-production p3s that steve thomas 
> engraved and routed 
> the cases for.

> There is a lack of clearance between the note board and the 
> memory board. 
> Specifically where the ribbon cable attatches to the pot 
> board theres a 
> conflict.  The upper pot board's connector seems, from what i 
> can tell by 
> peering in through the gap when i close the case, to clear.  
> This must, of 
> course, be due to the angle of the case...

I've seen that problem in a Hammond case too - the narrower, squarer one.
I replaced the right-angled ribbon cable connector with a straight one on
the lower pot board.
The cable may need rejigged to be a little longer between the two pot
boards, since this puts the lower connector further round.

Best regards,
Colin Fraser
Sequentix Music Systems Ltd
http://www.sequentix.com