Analogue-sequencer

If it gets as far as that screen, the bootloader is working.
It would be odd for the OS to be corrupt but not to show a checksum error at
boot.
Try reloading the OS using firmware update mode - FUNC+PAGE at power on.

Best regards,
Colin Fraser
Sequentix Music Systems Ltd
http://www.sequentix.com

 

> -----Original Message-----
> From: analogue-sequencer@yahoogroups.com 
> [mailto:analogue-sequencer@yahoogroups.com] On Behalf Of 
> boops.secretvibes
> Sent: 07 July 2008 23:02
> To: analogue-sequencer@yahoogroups.com
> Subject: [analogue-sequencer] Re: some help to finish my 
> first P3 version 1.4
> 
> hi,Colin ,i put the chip version 1.6 on the main board 1.4,unluckly
> the soft is freezing on this this screen     1/6 
>                                              BANK FTS TUNE
>  i 've tried F1+STEP 7 ,freeze again.
>  i've tried to get off the battery memories always 1/6 
>                                                    BANK FTS TUNE
> 
> any steps work...what can i do?:-( i 've maded this, cause i've got
> always this tempo (moove alone) problem on the version
> 1.4...nightmare..Best regards
> 
> 
> 
> 
> 
> --- In analogue-sequencer@yahoogroups.com, "boops.secretvibes"
> <boops.secretvibes@...> wrote:
> >
> > hi,thanks Colin for your informations..every seems alright for the
> > moment...for the two P3(just  change a lcd connection ,and 
> bootload)i
> > must try midi and learn the manual..also 2 memX for me 
> please(not just
> > one as i 've written)Best regards..
> > 
> > 
> > 
> > - In analogue-sequencer@yahoogroups.com, "Colin Fraser" 
> <colin@> wrote:
> > >
> > >  
> > > > -hello,i 've finished today the 2ND main board P3 kit 1.6 with
> > > > 3.006B,can i try it with my 1.4 others boards ,awaiting that i
> > > > bootload the 1.4 chip ?i 've got always this tempo problem with
> > > > this...work - no work (when i put my finger on the 3 pins of the
> pot,
> > > > working during a few seconds,ground problem?
> > > 
> > > There are two different clock speeds that the CPU may run at.
> > > Pre-production P3s used an 18MHz crystal, production 
> units used 24MHz.
> > > As long as the crystal speed matches the CPU, you can use 
> the later
> > chips in
> > > the early boards, and vice versa.
> > > Each CPU has the crystal speed it is meant to run at stored in
> > flash. The OS
> > > adjusts to run at either speed by checking that setting.
> > > 
> > > Best regards,
> > > Colin Fraser
> > > Sequentix Music Systems Ltd
> > > http://www.sequentix.com
> > >
> >
> 
> 
> 
> ------------------------------------
> 
> Yahoo! Groups Links
> 
> 
>