Analogue-sequencer

> Does this BOB include a PCB? Is it just routing or are there 
> also some 'active' components included?

It will include a PCB, but no active components. PCBs are the least
labour-intensive way to wire 25 sockets together.

> What is the pin-out of the SUB25 plug?
> Any pic's or drawings of this BOB somewhere?

I've got a schematic, and the functions of the pins are final, but not
necessarily the numbering.
My problems with the BOB are physical.
Of the two designs I had 'finished', the Hammond enclosure lids were too
small for the clamps on my suppliers' CNC turret press, and the rear
enclosure for the rack variant had insufficient clearance for folding.
The electronics, such as they are, are the easy bit.
 
> The Midi2CV's I currently use have multiples included (the 
> most used ones; 1V/Oct, Vel, Gate and slide have 4 multiples, 
> the other ones only have 2 multiples). This way I made 
> optimally use of rack space and saved me from building a few 
> multiples. (which actually I did when building the midi2CV's) 
> I was hoping to do the same with the BOB. If the enclosure is 
> big enough I might just drill some holes in it to add the 
> jack's ;-) But most likely I will build something myself.

I'm not planning to have it any bigger than it needs to be, but it may end
up with more space than needed just for the jacks if extra space is required
for fabrication.


Best regards,
Colin Fraser
Sequentix Music Systems Ltd
http://www.sequentix.com