Analogue-sequencer

Hi

Could be a few things.

Check the last step setting, or perhaps the steps are skipped. 

Also if I were you I'd initialise the P3 (presuming it wasn't new) so you
are starting with a clean sheet.

All in the manual but shout if you need help.

> >-----Original Message-----
> >From: analogue-sequencer@yahoogroups.com 
> >[mailto:analogue-sequencer@yahoogroups.com] On Behalf Of jdchevallier
> >Sent: 18 September 2011 03:43
> >To: analogue-sequencer@yahoogroups.com
> >Subject: [analogue-sequencer] Getting started
> >
> >Hello everyone. My P3 came in wednesday and I'm just sitting 
> >down with it. I'm running os 3.1, and hit a a a bit of a 
> >wall right off the bat. As I go into Pattern Edit mode, 
> >depending on the bank I'm in, the patterns just cycle 
> >through either 3 steps, or linger on the first. 
> >I can engage any of the other 16 steps, but the sequencer 
> >never moves onward to them. 
> >
> >I'm sure this is something quite simple, but I can't seem to 
> >figure this out. 
> >
> >Any help would greatly be appreciated.
> >
> >Thanks!
> >Joel
> >
> >
> >
> >------------------------------------
> >
> >Yahoo! Groups Links
> >
> >
> >