Analogue-sequencer

On Saturday 17 January 2004 03:00, Colin f wrote:
> > Okay Colin, what do I do?
>
> Open the case by removing the 6 screws along the front
> and rear edge of the base.
> Lift the top part off by tilting it up on it's rear edge.
> You will need to disconnect some of the cables to get the
> top to sit right back. Then look at this photo:
> http://www.colinfraser.com/p3/images/p3-005-inside.jpg
> That's pretty much how the inside of Boele's should look.

Apart from some women's underware stuffed between the pot 
boards, it looked identical yes.

> The pot boards are the long thin ones connected to all
> the pots, obviously.
> There are only two ICs on the pot boards. Take the two on
> the upper pot board out, and swap them over, making sure
> to put them into the sockets pointing in the right
> direction. You might need a little scremdriver to lever
> them out. Make sure to do it evenly at each end so the
> pins don't get bent.

Okay, I removed the two ICs from the upper potboard (the one 
printed 'Upper potboard', with no luck. Then I also swapped 
the ICs on the lower board. No luck either. I get the same 
repeating events from step #13.

Are there other options?

- Robert