Analogue systems

I have a number of ASys modules in my Doepfer cases and have no 
problem with the mounting holes. Both Doepfer and ASys can mount on 
the Doepfer rails. The only difficulty is that the mounting holes on 
Doepfer are slightly farther from the edge of the module than are 
the ASys. Because of this, if a Doepfer and ASys module are mounted 
side by side, you end up with a space of about 1/2 hp between the 
modules. I get around this by not mixing ASys or Doepfer in a single 
row.  If each row is either all Asys or all Doepfer, then there is 
no problem.  
   

--- In analogue_systems@yahoogroups.com, "selfoscillate" 
<synaptic_music@y...> wrote:
> 
> analogue solutions can supply both types of connectors,
> but they ship doepfer as default.
> 
> best wishes
> 
> ingo
> 
> 
> --- In analogue_systems@yahoogroups.com, Loren Nerell 
<lnerell@e...> 
> wrote:
> > At 07:31 PM 4/7/2004, you wrote:
> > >Doepfer and Bob do not use the same connectors, nor
> > >the same pin orientation (what voltage goes where on those 
> connectors) and
> > >there have been too many miswires when people attempted to make 
> mating
> > >cables.
> > 
> > What about analog systems vs analog solutions? Are their 
> connections 
> > different or the same?
> > 
> > 
> > Take care.
> > 
> > - Loren Nerell
> > 
> > -------------------------------------------------
> > http://home.earthlink.net/~lnerell/
> > http://www.soundclick.com/lorennerell
> > -------------------------------------------------  
> > 
> > [Non-text portions of this message have been removed]