Bc2000 (for the BCF2000 & BCR2000)

Thank You for all the information, and for sharing your solution to joining these two units together....I really appreciate it!




--- In bc2000@yahoogroups.com, "KrisV" <azymbol@...> wrote:
>
> 
> 
> --- In bc2000@yahoogroups.com, "e_buy_sell" <e_buy_sell@> wrote:
> >
> > Flat out fantastic! Have you decided on a price, with shipping in the USA? Please let me know!
> > 
> > --- In bc2000@yahoogroups.com, "azymbol" <azymbol@> wrote:
> > >
> > > http://groups.yahoo.com/group/bc2000/photos/album/47268658/pic/list
> > >
> >
> 
> glad to hear you liked the mod.
> I got the same question about making the panels and sending them
> to the USA in february.
> Seems like shipping these over would cost at least 2 times more than making them as I'm living in Belgium.
> 
> Your best option is to print the pdf (in files section) at 100% and stick it together to make a template.
> Disassemble the original side panels (and front panel of the top BC)
> Put the 2 controllers on their side and see if the screw holes of the 
> template match the holes in the BC's.
> Then find a local woodcutter and show him the template.
> 
> DIY option:
> find 2 pieces of wood or MDF(I used MDF 9 millimeter thick so the original screws could be used)
> attach the template to the wood/MDF with (double sided)tape,put the second piece of wood under it and drill the screw holes. I put 4 wood screws in the drill holes to stick the 2 pieces of wood together so they won't slide while cutting them. 
> Now cut along the lines of the template with a decent jigsaw.
> After cutting,remove the wood screws and use some sand paper to remove
> the rough edges.
> 
> I hope this helps...
>