Bc2000 (for the BCF2000 & BCR2000)

Robin,
there is a list to the left of this message
Click on Files and look for the Preset folder on the next page displayed.

Royce

--- In bc2000@yahoogroups.com, Robin Lont <robinlont@...> wrote:
>
> Hi Royce,
> 
> Thanks for this information, i have been a bit busy lately. I will see what ik 
> can do.
> Where can i find the Files/preset of the group?
> 
> Best
> 
> Robin
> 
> 
> 
> 
> ________________________________
> From: Royce <rpcfender@...>
> To: bc2000@yahoogroups.com
> Sent: Wed, August 25, 2010 4:38:55 AM
> Subject: [bc2000] Re: Tweaking on a BCR/BCF?
> 
> Â  
> Re: Tweaking on a BCR/BCF?
> 
> I have created a simple CC on channel 1 preset for the BCR.
> It is in the Files/Preset section of the group.
> 
> If you are using Mark's editor it will load either file.
> If not you can send the sysex to the BCR2000
> 
> Encoder 1 to 56 (4 banks in the top row) are CC 20 to 75 with a range of 0 to
> 127
> Button 1 to 48 (4 banks of encoder switches and 2 button banks below) are CC 76
> to 123
> 
> > Oh ofcourse i forgat, i am using Sonar 8 Producer.
> 
> Using Sonar ACT - take a deep breath, I hate ACT.
> 
> Enable the BCR Midi In and out
> Options/Controllers/Surfaces
> Add 'ACT Midi controller'
> Select the In and out ports to the BCR
> Check the ACT and WAI (Where am I) boxes for the BCR
> Close
> Tools should now have an option 'ACT MIDI Controller' select it
> Drop down the Presets box and select Behringer BCR2000 (Custom)
> 
> Decide what rows of encoders you want to use - let's use the 3 banks of non
> switched lower encoders to match the ACT layout
> Click on the 'Enc 41' and you can change the Label if you want to.
> Click on the area below the label and it will say 'midi learn'.
> Twist the BCR Encoder (top left) and Sonar will store and respond to the data
> coming in (it should read 0% to 100%)
> 
> It can sometimes take a second or two to make this register.
> 
> Once you have finished save the ACT preset
> Keep this dialog open
> 
> Now to connect the ACT BCR to Massive
> Insert a synth track of Massive
> 
> Click the Massive dialog to make sure it is the active window.
> The ACT Controller dialog should change showing the attached Massive parameters.
> Click on the ACT button in the Massive dialog (top right)
> Move a Massive control then twist a BCR encoder to link the two.
> Repeat this for all the other controls you want to link
> Click on the ACT button again and it should bring up a messages box about x
> Parameters and x Controls etc. Press Yes
> 
> They are now linked. When you exit Sonar the linking file is saved
> 
> All the best
> 
> Royce
>