Bc2000 (for the BCF2000 & BCR2000)

See a previous message thread about "noOS", in particular the bottom part of http://launch.groups.yahoo.com/group/bc2000/message/2337 .

In any case: under "noOS" you can't use USB at all.

So you should do the following:

1. Put the BCF in operating mode S-4.

2. Connect your computer's MIDI OUT to the BCF's MIDI IN.

3. Connect your BCF's MIDI OUT A to your computer's MIDI IN. (Whether this is necessary depends on the method you choose under point 4 below.)

4. Use one of the methods described in the above-mentioned message to upload the firmware. (See BC Manager's manual p. 37 for info about BC Manager's "Send firmware" operation.)

Good luck!
   Mark.