Bc2000 (for the BCF2000 & BCR2000)

Hi Steve,

 

I am using the .NET 4 framework and im using the C# language.  If there
weren't so many parameters I would have been done long ago, but it will be
worth it when im done. 

No VST version but that would be nice.

 

Greg



From: bc2000@yahoogroups.com [mailto:bc2000@yahoogroups.com] On Behalf Of
sghookings@...
Sent: Thursday, July 21, 2011 4:45 PM
To: bc2000@yahoogroups.com
Subject: [bc2000] Re: Programming BCR for the Dave Smith Evolver Desktop

 

  

Out of interest Greg, what framework are you choosing for your software?
VST, Java, c# ???

I always wanted to get into the Steinberg VST thang but to date have not
managed to grasp the midievent examples.

Regards 
Steve H
--- In bc2000@yahoogroups.com <mailto:bc2000%40yahoogroups.com> , "Greg
Long" <greg.web.dev@...> wrote:
>
> Not only do I have a preset for the Tetra on the BCR2000 but I am working
on
> software that loads the data from the current patch into the BCR2000 so
you
> can see the patch.
> 
> Right now only layer A is populated with data but is makes a big
difference
> to see the patch before editing it from the BCR. 
> 
> 
> 
> All of the buttons and encoders are setup to use NRPN's to control the
> Tetras parameters.
> 
> 
> 
> 
> 
> 
> 
> From: bc2000@yahoogroups.com <mailto:bc2000%40yahoogroups.com>
[mailto:bc2000@yahoogroups.com <mailto:bc2000%40yahoogroups.com> ] On Behalf
Of
> longstrongturtle
> Sent: Wednesday, July 20, 2011 9:22 PM
> To: bc2000@yahoogroups.com <mailto:bc2000%40yahoogroups.com> 
> Subject: [bc2000] Programming BCR for the Dave Smith Evolver Desktop
> 
> 
> 
> 
> 
> Hey Folks, I downloaded the templates for the Evolver Desktop off this
site
> and it seems like the templates use System Exclusive messages to change
> settings on the Evolver Desktop. All of the knobs in these templates go
from
> 0-127 which doesn't make sense considering a lot of the parameters on the
> Evolver have different ranges, for example one parameter has a range of
> 0-200 on the Evolver and some have a range of 1-4.
> 
> I have an Evolver with the version 3.0 operating system which allows you
to
> use MIDI Continuous Controller mapping, the previous versions only used
> System Exclusive messages which is what the presets on here were written
> for. Now what I am wondering is if I programmed a preset for the BCR-2000
> using CC mapping instead of SysEx, would the LEDS move to their relative
> positions when I change presets on the Evolver Desktop? Currently, when
> changing patches on the Evolver Desktop, the knobs remain where they are
on
> the BCR even if I have the midi out from the Evolver Desktop going into
the
> midi-in on the BCR-200. That is what i'm most confused about and couldn't
> find a clear answer about. Thanks!
>