that link works fine here, might be your email client is splitting it.
or just grab the preset from the files/presets bit of this group.
Sent from Yahoo! Mail on Android
From:
Robert Krueger ;
To: ;
Subject: Re: [bc2000] Re: Programming BCR for the Dave Smith Evolver Desktop
Sent: Wed, Aug 3, 2011 9:34:40 PM
To: ;
Subject: Re: [bc2000] Re: Programming BCR for the Dave Smith Evolver Desktop
Sent: Wed, Aug 3, 2011 9:34:40 PM
"Document not found"
On Wed, Aug 3, 2011 at 4:10 PM, massenmedium <massenmedium@...> wrote:
Did you try my template?
It might be a little idiosyncratic, the best 1 page layout I could decide on for my purposes at the time, but the parameters are all mapped to the correct ranges etc.
Massimo
http://f1.grp.yahoofs.com/v1/wKg5Tv8swY2Z0NCon9jYb0omqlz9TQtwLzbWwOoXlWi7KdgkN2SFJ-v8yDhdlBgOcHFTZhx7mB25x37jxsOg110n9PUeMysYugIm/Presets/Massimo%27s%20BCR2000%20Evolver%20Map%201.1.zip
--- In bc2000@yahoogroups.com, "longstrongturtle" wrote:
>
> Hey Folks, I downloaded the templates for the Evolver Desktop off this site and it seems like the templates use System Exclusive messages to change settings on the Evolver Desktop. All of the knobs in these templates go from 0-127 which doesn't make sense considering a lot of the parameters on the Evolver have different ranges, for example one parameter has a range of 0-200 on the Evolver and some have a range of 1-4.
>
> I have an Evolver with the version 3.0 operating system which allows you to use MIDI Continuous Controller mapping, the previous versions only used System Exclusive messages which is what the presets on here were written for. Now what I am wondering is if I programmed a preset for the BCR-2000 using CC mapping instead of SysEx, would the LEDS move to their relative positions when I change presets on the Evolver Desktop? Currently, when changing patches on the Evolver Desktop, the knobs remain where they are on the BCR even if I have the midi out from the Evolver Desktop going into the midi-in on the BCR-200. That is what i'm most confused about and couldn't find a clear answer about. Thanks!
>