Bc2000 (for the BCF2000 & BCR2000)

--- In bc2000@yahoogroups.com, "maximo" <tomaximo1@...> wrote:

> The firmware of my BCN is 1.02, is this one the latest

Yes, as far as I know.

> parameter feedback does not work on the BCN! When i move the software sliders the knobs don´t update! 
> I looked at the manual and it did not say anything about it. Am i doing something wrong or the BCN really does not have this feature?

I've just run some tests on my own BCN44 using BCN44 Manager:

Like you, I can't get parameter feedback to work at all;
not for the buttons, not for the encoders.

The encoders don't have the BCR/BCF2000's LED circles, so for the encoders you wouldn't immediately see any parameter feedback anyway.
But when I send a CC message to the BCN and then turn the pertinent encoder, it's always still at its old value.

The buttons do have LEDs, but these LEDs never change upon parameter feedback, and neither do the buttons' actual on/off states.

So it appears that the BCN44 doesn't support parameter feedback at all.

Mark.