Bc2000 (for the BCF2000 & BCR2000)

Hi, 

Best care tips : 

 - eventually remove the side panels for easier access
 - get yourself compressed air; like they got in diving bottles
 - blow away all dust and dirt 
 - use teflon on the outside / contact spray on the inside
 - do not use contact-spray in excessive amounts
 - let dry for a few hours

After this maintenance; your buttons might be working again. 

If not; there might be a soldering which went bad or a button not making contact as it should.

With friendly regards,

Gunther / Freaking Wildchild.

--- In bc2000@yahoogroups.com, "oversampler" <nice1ruari@...> wrote:
>
> Hi
> 
> I think I may have a problem with my BCR2000, the trouble is I'm not sure if it's something that is normal because it is a Behringer product & I should expect it to have quirky behaviour or if I should try & return it to where I bought it. I think that it probably is broken but I wanted to check here to see what other people thought.
> 
> I'll try & describe what it is doing
> 
> The Edit/Store/Exit/Learn buttons don't always do what they should when I press them, it can sometimes be difficult to enter Global Setup by holding Edit then pressing Store - the Edit button doesn't light up when pressed & sometimes the Learn button will light up as I press Store. Occasionally the display will show PANc
> 
> Pressing Edit & turning any knob or pressing any button isn't taking me to any kind of edit mode.
> 
> Pressing Learn & turning a knob sometimes takes me into Global Setup (the Edit & Store buttons light up when it does)
> 
> The preset right button works ok, the left one is intermittent - usually I'm having to press the right one & turn encoder 1 to get back down the presets. Both of the buttons seem to function normally if I press store then try to select a destination preset.
> 
> The LEDs around the knobs seem to light up in sympathy when other knobs in that row are being turned, with all the knobs in a row on a different setting all the knobs have a halo of lit LEDs surrounding them. When I have been trying to set these LEDs up I've always been going for the 1d option.
> 
> I tried re-installing the firmware 1.10 to see if that would help but it hasn't made any difference.
> 
> What do you think, does it sound like this is broken?
> 
> I've only had it a couple of weeks, I bought it second hand. I could live with the LEDs being a bit funny but it's very frustrating trying to programme it with the Store/Edit/Learn/Exit buttons only working properly every now & then.
>