Bc2000 (for the BCF2000 & BCR2000)

I was going to run a BCR2000 for Plugins . But after a lot of research I went with the Nektar P1 .. Because of the screen that tells you everything when you are programming it .... But, On the BCF , Make sure your using midi out as midi in & midi in as midi out .. If your using midi cables ... Cause In is out & our is in ... But, you probably already know that . Old MIDI Saying as it were ..


Sent from Yahoo Mail for iPhone


On Thursday, June 7, 2018, 8:15 AM, redcardsound redcardsound@... [bc2000] <bc2000@yahoogroups.com> wrote:

    
Do not know if it helps . Cause I only run one BCF2000 ... I just turn it off , turn it back on holding down 3 & use it in logic mode . To control faders ..... Otherwise go into the settings on Live & make sure you are setting a controller up .. Like Prefrences/Settings & Controller ..... Other than that , I can tell you that the BCF will work right after a month of playing around .... Lol ! Not kidding ! It took me a month before I was actually using mine ....


Sent from Yahoo Mail for iPhone



On Thursday, June 7, 2018, 3:07 AM, duckdive@... [bc2000] <bc2000@yahoogroups.com> wrote:

    


I've been reading about different stuff about my BCR2000s.  I bought two of them online from two different people.




They are both at 1.10 firmware.  They power up.  They are detected on my Mac (Audio/MIDI) and in Live.




I can use the Edit & Store buttons to get to Global Setup to change the USB/Standalone modes on both of them.  I have detected both of them with BCManager, and also changed the mode that way as well.  I've also run the BCManager hardware test without issue.  I've even reloaded the firmware.




Yet, I'm unclear if they are working.  Because I cannot get any MIDI to be sent to Live.  All I really want to do is to be able to use all of the knobs to MIDI map Live & Reaktor VST.

I've tried MIDI Monitor to see if any messages can be detected either on USB (modes) or via Standalone (modes) with DIN to two different soundcards with MIDI in.  In both cases, I do not see anything in MIDI Monitor or even in Live (in the little box in upper right).




I hope that this is something easy that is a RTFM type thing.  I browsed through the manual, but I don't see anything that helps.




Can anybody advise?