Bc2000 (for the BCF2000 & BCR2000)

I also get a message from the system tray when I turn the BCR on: 

"Windows - System Error"
"The I/O device reported an I/O error."

It actually worked in U-3 mode for a bit, till I tried out U-1 and
since then, no USB modes work, not even U-3!

Regards,
-Ryan

--- In bc2000@yahoogroups.com, "rpcfender" <rpcfender@...> wrote:
>
> Hi Ryan
> 
> It turns out it didn't work fully, I got the system buttons working OK,
> sending CCs, but the preset keys don't send a CC at all.
> 
> Here's the main part of my preset, not including the other encoders &
> buttons:
> 
> This works fine for me. The buttons put on channel 3 CC $71 or $72 with
> a 'down' value of $7f and a release of 0
> Check that you haven't redefined them lather in the preset. The BCR is
> happy to redefine the button over and over again in the one preset. This
> usually happens when you cut and paste and forget to change the button
> number.
> 
> You could try just this snippet and if it works how you want it to then
> it will definitely be  a redefinition.
> You haven't defined $preset after  the buttons. The .init will clear
> your settings.
> Again the BCR is happy to have any number of $preset sections and it
> will clear everything that has gone before.
> 
> Other than that, it looks good.
> 
> $rev R1
> $preset
> .name 'TRAKTOR (P2)            '
> .snapshot off
> .request off
> .egroups 4
> .fkeys off
> .lock on
> .init
> $button 63
> .easypar CC 3 113 127 0 toggleoff
> .showvalue on
> $button 64
> .easypar CC 3 114 127 0 toggleoff
> .showvalue on
> $end
> 
> All the best
> 
> Royec
>