Bc2000 (for the BCF2000 & BCR2000)

Hi guys. Does anyone know if there is a way of setting up the bcr2000 in this way:

-Turning a knob / pushing a button sends values to midi out / usb
-any data sent to the bcr2000 from usb, updates the leds on all knobs/buttons, but does not send back out through midi out / usb

My idea is this:

An LFO in Reaktor is sending data to one of the knobs, so the LED on that knob is displaying the speed of the LFO. When turning the knob, it sends MIDI to Reaktor as it would normally.

At the moment, if the LFO data is sent to the BCR then the data is sent back into Reaktor causing the knob in reaktor to move back and forth at the speed of the LFO, causing horrible midi feedback.

Set one of the buttons to a CC you are not using
$button 52 ;bottom right
.easypar CC 01 127 0 1 toggleon
.showvalue on
.default 0
Now send 0 and 1 to the BC with CC channel 1 127 and the LED will go off and on.

If you are not using all the groups in the top row you could set
.egroups 2
and use button 59 or 60

All the best
Royce