Hi Anddrew, *many thanks*! Well, my learning curve on electronics
isn't steep. Actually I'm progressing slowly. An Analog Logic is
done and the Burst Gen will be done. Regards, Ilanode
isn't steep. Actually I'm progressing slowly. An Analog Logic is
done and the Burst Gen will be done. Regards, Ilanode
--- In cgs_synth@yahoogroups.com, "bbluthang" <jumpswine@h...> wrote:
>
> hi
> > On the pcb of Burst Gen there is a pad CLK O is that a clock
> output?
>
> the Clk O connects to the 'switch' on the clock-in jack.
> if nothing is plugged into this jack, you can set the burst gen up
> with the speed pot and range switch. once you plug in, this part
of
> the circuit is disconnected.
>
>
> > I'm
> > shopping for parts and wonder if I could replace the VOLT value
of
> > electrolytic caps by any other value as long as it is higher
than
> > the PSU used puts out: Can I use 47uF 16V instead of 47uF 25 V
(for
> > the Burst Gen.)?
>
> if running 15v, i'd feel uncomfortable using a 16v electro for
> decoupling. it is okay to go bigger than 25V. 10uF 35V or 50V
would
> be fine.
>
> hope it all goes well
> cheers
> andrew